Filter
Top Products
12
• In the centre of the intended position of the turntable, drill the opening for the cable gland with a
circular cutter (Ø: 38 mm). Deburr the hole with a round fi le or emery paper.
• Provisionally insert the roof gland into the drilled hole (Fig. A).
• Place the mounting plate on the roof of the vehicle, such that the centre hole is positioned centrally to
the cable gland. The arrow symbol must be visible from above and point forwards in the direction
of travel (Fig. B).
• Mark the positions of the ten fastening holes on the roof of the vehicle in a pitch circle.
Note: The size of the holes and the choice of fastening screws to be used (not supplied) depend
on the type and thickness of the materials used in the roof structure. If the roof panelling
(plastic roofs) is suffi ciently strong, it is recommended that round head screws, plain
washers and self-locking nuts are always used to secure the glued mounting plate.
Figure: A
Figure: B
Note: If you had previously used a Kathrein HDM 140/141 jointed tripod mast or another mast
with a diameter of 34 mm, you can continue using the existing through hole in the roof
(if space allows).
INSTALLATION STEPS
INSTALLATION OF CABLE GLAND AND MOUNTING PLATE
INSTALLATION AND CONNECTION
Adhesive