Filter
Top Products
52
After a change of location, the antenna moves to the last position selected. After initialisation, you will
therefore see the following display (example, as it depends on the last selected position):
For slight changes of location, the
antenna can fi nd the satellite very
quickly.
If the search is unsuccessful, the following message appears:
CHANGE OF LOCATION
If the satellite is not found at the known position, the search starts automatically.
Note: To help ensure the required satellite is found quickly, the CAP 910 uses GPS data
recorded during the journey. However, GPS data is only recorded if both the green ignition
lead and the turntable are connected to the 12 V power supply (the receiver can remain
switched off). If this is not possible, we recommend that you connect the turntable and
the ignition signal to the 12 V power supply for approximately 3 minutes before setting
up the system. The current GPS data will be provided during this time. Once the ignition
signal has been removed, the receiver can be switched on. The CAP 910 now searches
for satellites using the exact elevation.
The search starts automatically after fi ve seconds or if the
button was pressed previously.
The search may take a few minutes (generally about two minutes). You will fi rst see the following message: