Filter
Top Products
51
TIMER PROGRAMMING
To prevent the turntable rotating at a time when it is unsupervised or when
rotation might be irritating (e.g. in the middle of the night), a timer can be
set. During the timer period the turntable is active only if the UFS 940sw is in
operation or is in standby mode.
If the receiver is completely switched off (switched off at the power socket)
and/or the turntable is in park position, the turntable will be inactive during the
timer period! The same applies if during the fi rst movement the satellite position
is not found.
See the UFS 940sw operating manual for details of how to program the timer. When using the
UFS 940sw on a CAP 910 please note the following additional instruction:
Note: A comprehensive explanation of the channel list with its detailed functions (e.g. the scan
and sort function) can be found in the UFS 940sw operating manual.
view the currently selected channel in the small window at the top right. To exit the channel list and return
to the TV picture, press the
button again, or press the
button.
CHANNEL (SATELLITE) SELECTION/PROGRAMMING THE TIMER
The timer function is currently not yet available in CAP mode!
To view the channel list sorted by the saved satellites, proceed as follows. Press the
button (starting
from the TV picture). If the “green view” does not appear in the complete list, press the
(green) button.
Now use the
buttons to select the desired satellite. You will automatically see the channel list
stored for the satellite (see example):
CHANNEL SELECTION FROM THE CHANNEL LIST (SORTED BY SATELLITE)
The channel selection functions as previously described “Channel selection from a channel list”.