Filter
Top Products
24
INSTALLATION AND CONNECTION
Under certain circumstances, problems can arise when the units are connected to different connecting
sockets or circuits/earth potentials. If none are available, it is recommended that you connect the
connecting sockets for receiver and TV set to the same cable, as depicted in Figure “G”. The power
rating of the circuit used must be checked with respect to the intended application.
Further information on operating the UFS 940sw receiver can be found in the operating manual
supplied with the unit.
Only for connection in a motor home, not in a caravan!
• The third, green connecting cable, marked “IGNITION” allows you the option of connection to a
circuit in the vehicle that is activated when the ignition key is turned and then carries a continuous
12 V supply. This type of connection ensures that when the engine is started the antenna
is automatically lowered into the park position (the receiver does not need to be turned on).
Note that the antenna can then be lowered only when the power supply is present in addition to
the ignition signal!
• Check the connections before you re-connect the on-board power supply.
• For commissioning and more detailed information on additional operator functions, please consult the
operation section of the separate operating manual for the receiver.
FUNCTIONAL INSTRUCTIONS FOR CONNECTION TO THE ON-BOARD POWER SUPPLY