Filter
Top Products
55
SPECIAL MESSAGES FROM THE TURNTABLE
The following messages are shown on the screen to protect your reception system and the on-board
power supply:
SYSTEM PROTECTION MESSAGES
The power supply to the turntable is inadequate (battery voltage below the minimum value). The turntable
can still be moved, but communication errors can occur between the UFS 940sw and the turntable
(e.g. when scanning for satellites).
If the voltage falls still further, both the following error messages are displayed:
Check the power supply to the turntable and
whether it is obstructed (e.g. by a branch). If
neither of these causes of faults is displayed, the
turntable motor temperature is in the critical range.
Allow the turntable to stand for a few minutes
in its current position, until the turntable motor
temperature has reduced. You can also however
move the turntable to the park position and let
it cool down there.
Press the
button and the turntable will move
to the park position.
Press the
button to confi rm the displayed
message. The turntable cannot be moved any
more. Check the power supply to the turntable.
Note: The antenna should not be moved whilst the battery is being recharged, to prevent peak
loads when turning on.