Filter
Top Products
23
INSTALLATION AND CONNECTION
• Lay the master coaxial cable (marked red) to the UFS 940sw and the second coaxial cable to the
second receiver. If you are not using a second receiver, we recommend that you lay the second
coaxial cable in any case, so that it is available should you ever need it.
• Lay the turntable power supply cable (3-pin plug) to the battery.
Avoid laying the cables across sharp edges and secure the cables against possible chafi ng
points.
• Connect the master coaxial cable (coming from the turntable) to the “IF IN” F socket on the rear of
the UFS 940sw.
• Place the infra-red sensor for the receiver close to or directly on top of the TV set and lay the
cable to the UFS 940sw. Connect the 6-pin Western connector at the rear to the socket marked
“IR REMOTE IN” (see also “Installation of the UFS 940sw receiver” in this section).
LAYING CABLES AND CONNECTING THE TURNTABLE
CONNECTING TO THE UFS 940SW
Note: Lay the Cinch cable supplied with the CAP 910. Take great care to plug the cable into the
correct socket!
Isolate the on-board power supply (master switch “off” or disconnect the positive pole of the on-board
power supply battery) before commencing the following work:
• Connect the power cable supplied (depending on the power supply available in your motor home
or caravan, either a 12 V supply or a 230 V supply via a power supply unit) to the “
”
plug connector on the receiver.
Make sure that the “inline” integrated fuse (5 A) of the cable is fully plugged in and is intact. If the
fuse blows, the source of the fault must fi rst be eliminated. The fuse must only ever be replaced
by a fuse with the same rating (5 A).
The receiver must be connected to no other power supply than 12 V DC. The
receiver’s earth connection must be connected to the negative pole of the motor
home or caravan battery.
• At the connecting point for the power cable, the voltage must not fall below 10.9 V even with a load
of 12 A. Otherwise optimum functioning can no longer be guaranteed.
• Connect the power cable to the respective socket in your motor home or caravan (12 V or 230 V).
The fuses in the cable and in the receiver must never be by-passed – cable fi re
hazard!