Filter
Top Products
Initial Setup
18
Receiver Factory Satellite Setting
Your receiver is factory-set up for the satellites listed in the following
table. You do not normally need to make any additional settings.
ASTRA
19° East
HOTBIRD
EUTELSAT
10° East
EUTELSAT
16° East
TürkSat
42° East
(EURASIA)
Telecom
5° East
(AtlanticBird 3)
Telecom
8° East
ASTRA 28.2°
East (EURO-
BIRD 28.5°)
Telestar12
15° West
Hisparsat
30° West
EUTELSAT
7° East
Amos 4° West
Thor 1° West
(Intelsat 707)
Sirius 5° East
Arabsat
26° East
Time/Timer
”
section).
If the message “
Poor or no signal
” appears on the screen as well as
the display for the last programme received, check the installation of
the system and/or the receiver settings. If this only affects individual
programme slots, there may be an interrupted signal from the
broadcaster or a fault in the reception system.
First of all, check the connection confi guration and whether the default
receiver settings are correct for your system. In case of doubt, consult
a specialist engineer.
This message appears when
“HDP mode” is deactivated.
Press
to switch to the main
menu, and then use the
keys to call up the “HDP Antenna Se-
tup” sub-menu. Use the
keys to call up the “HDP Antenna Se-
keys to call up the “HDP Antenna Se-
keys to
change the selection to “On”. Pres-
sing the
keys takes you back to
the normal TV screen.