Filter
Top Products
Manual Lowering to Park Position
75
1. A plastic cover is located in the centre of the axis
(see arrow). Lever this off with a narrow slotted
screwdriver.
2. Behind the cover is an M8 hexagon head screw.
Unscrew it using a socket wrench, size
13 mm
.
After removing the M8 screw, a further thread can be
seen.
3. Attention! Secure and support the antenna to prevent
it tipping over. The connection to the rocker can
suddenly come loose during the next step (point 4).
It is then no longer connected to
the
turntable.
4
. Screw an M12 screw into this thread (minimum
length: 22 mm)
. You will need a
socket wrench for
this (size: 19 mm
).
Screwing in the M12 screw
removes the rocker from the tapered shaft and
releases the catch.
5.
Tilt the antenna into park position (horizontal position).
6. Remove the M12 screw. T
his replaces the
rocker on
the tapered shaft.
7. Replace the M8 screw and tighten it
.
8. Replace the plastic cover.
Removing the rocker from the tapered shaft moves the
position of the rocker zero point. An authorised dealer
should eliminate this defect and calibrate the rocker.
9
. Consult an authorised dealer.
Manual Retraction