Filter
Top Products
Setting System Parameters
48
With the factory setting, the receiver indicates the “UTC” (United Time
Coordinate, previously Greenwich Mean Time), which is transmitted
with the data stream. For Germany, the time must therefore be correc-
ted by +1 hour.
To do this, move the cursor bar to the “Local Time/Timer” menu option
using the
key. You can use the
To do this, move the cursor bar to the “Local Time/Timer” menu option
To do this, move the cursor bar to the “Local Time/Timer” menu option
keys to correct the time for-
wards or backwards in half-hourly intervals.
If the time displayed by the receiver differs from the correct time by just
a few minutes, proceed as follows:
- Use the
keys to go to the “Local Time/Timer” menu
option and change the time by approx. 10 hours (forwards) using
the
option and change the time by approx. 10 hours (forwards) using
option and change the time by approx. 10 hours (forwards) using
keys
- Then fi rst press
to switch the receiver to
Standby mode, and disconnect it briefl y from the power supply for a few
seconds using the power switch.
- Start up the receiver again and, from the main menu, switch to the
“System Parameters” sub-menu and then to the “Local Time/Timer”
option.
- If necessary, correct the time in half-hourly intervals with the
keys until the correct time is displayed.
Pressing
twice takes you back to the normal TV picture.
Local Time/Timer
Help for the selected item
is available by pressing
the
key. Press the
key again to exit the
Help menu.
Here, you can use the
keys to specify whether your TV set is a
- PAL
- Multi-standard or
- NTSC set.
Pressing
twice takes you back to the normal TV picture.
TV Type
Picture Format
Here, you can use the
keys to select the type of picture format for
which your TV set is designed. This will either be
- 4:3 format
- 16:9 format or
- Auto
Pressing
twice takes you back to the normal TV picture.
You
may need to
correct the
“
Summer-
time
”
set
ting
. Use
th
e
keys
to go to the
“
day-
light savings time
”
option. Here, you can
use the
option. Here, you can
option. Here, you can
keys to
turn this time setting on
or
off.
Note:
After doing this, do
not
initially turn off the receiver with
not initially turn off the receiver with not
th
e power switch
but
use the
but use the but
remote control for this pur-
pose, as otherwise the settings will
be lost
.