Filter
Top Products
At the margins of the footprints of a satellite (e.g. after a slight change
of position), it may be necessary for you to manually correct the setting
(not normally required). It is also possible to manually correct the fi ne
tuning.
Press
in the main menu and then use the
keys to switch to the “HDP antenna setup” option. Then press
to go to the HDP menu.
Alignment (Satellite Search)
65
Manual Correction
The set position (the satellite found) is saved.
You can correct the inclination and horizontal angle of the antenna
using the “Elevation” and “Azimuth direction” settings. To do this, press
the
keys or enter a fi gure using the number keys and confi rm
with
. Check your settings by referring to the “Level” and “Qual”
bars on the left-hand side. The higher the bar, the stronger and better
quality the signal received. At the same time, you can use the
key to activate a search tone, the level of which corresponds to the
signal strength. The graphical display in the lower section of the screen
(green with red dot) represents the relative position of the antenna.
While the antenna turntable is moving in the desired direction, a cor-
responding message for Elevation and Azimuth direction appears (ex-
ample).
After successful fi ne-tuning, the following message appears for a few
seconds: