Filter
Top Products
Connection and Setup
8
The following section is intended specifi cally for specialist
dealers. You only need to pay attention to this section if you are
carrying out the installation yourself.
The
“
Connection diagram
”
section contains a sample
confi guration.
Do not connect the unit to the mains until all installation work
has been properly carried out. Refer to the information in the
“
Safety instructions
”
section.
Connecting the Unit
Connect the SAT-IF input on the UFD 170 to the satellite receiving sys-
tem. Use a coaxial cable with a standard F connector.
If the F connector is not yet fi tted on the cable, strip the insulation from
the cable as shown in the following illustration and carefully twist the
F connector onto the end of the cable until it is securely fi tted on the
cable.
When fi tting the connector, make sure that no wires from the braiding
are touching the inner conductor - this could result in short circuit.
The quality of the reception signal depends on the connection.
SAT-IF Connection
Receiving Requirements
Receiving System Presets
Make sure that your own satellite antenna system is equipped with at
least a universal LNB for digital reception in the high-band range.
The presents for the control signals have been made for standard
reception systems, i.e. 14/18 V for polarity reversal and 22 kHz
switching signal for low/high band changeover on multi-feed reception
systems.
7 mm
10 mm
If you will be using the UFD 170 in conjunction with a CAP 210 or
CAP 310 from Kathrein, the installation instructions for the relevant
CAP unit must be followed during installation.
braid bent back