Filter
Top Products
Help on Parser Commands
Function: lists parser commands
Command: HELP
Argument: none
Response: print a list of all parser commands
G.2 Manual Positioning Commands
To execute the following commands, first put the Antenna Unit in
idle mode by typing
HALT and pressing “ENTER.” Positioning
commands may be entered after the antenna comes to rest.
Azimuth Angle
Function: commands a manual azimuth angle that the
mechanism moves to
Command: AZ,xxxx (range is 0000-3599)
Argument: desired azimuth angle of the mechanism relative to
external magnetic reference, or baseplate fwd,
000°-359.9°
Response: echoes the command; mechanism moves at a
fixed velocity
Elevation Angle
Function: commands a manual elevation angle that the
mechanism moves to
Command: EL,xxx (range is 100-850)
Argument: desired elevation angle of the mechanism relative
to up, 10.0°-85.0°
Response: echoes the command; mechanism moves at a
fixed velocity
Azimuth CW Step
Function: commands a 0.1 deg CW manual step in azimuth
angle
Command: 6
Argument: none
Response: echoes the command
G-2
A Guide to TracVision 4
Table G-2
Manual Positioning Commands