Filter
Top Products
21
Timer Recording (cont'd
8 11
Press the Number 1 button to record in
SP speed, press the Number 2 button to
record in LP speed, or press the
Number 3 button to record in SLP
speed. For details, see page five. You
cannot use the (Tape) SPEED button at
this time.
EL 10
T ON _:_1 PM
TIME OFF 11:00PM
TO CORRECT PUSH CLEAR
"%_ END PUSHEXIT
9
Press two Number buttons for the
month and the day you want to record
the program. For example, for July
10, 1996, press 07, 10. The day of the
week and the year will be displayed
automatically (you cannot program the
VCR to record more than one year in
advance).
CHANNEL l0
I TCI_ ON 09:30 Pld
I TIME OFF 11:00 Pld
i RECSPEED SiP
I START DATE 07/10/_
WED.
k TOCORRECT PUSH CLEAR
_TO END PUSHEXIT
10
Press the STATUS/EXIT button.
PROGRAM WAS COMPLETED
PLEASE TURN OFF VCR FOR
TIMER RECORDING will appear on-
screen (if PROGRAM NOT COM-
PLETED appears, try again from step
1). In three seconds the on-screen dis-
play will disappear. Now, go to steps
11 and 12.
If you want to program another timer
recording, press the MENU button.
Repeat steps 2 - 10. If you don't want
to program another timer recording, go
to step 12.
12
Turn off the VCR power. The Timer
light will appear. The VCR must be
turned off for a timer recording to
take place. If you forget to turn the
VCR off, PLEASE TURN OFF VCR
FOR TIMER RECORDING flashes
on your TV screen two minutes before
a timer recording starts. You can
remove it by pressing the CLEAR but-
ton.
The VCR
must be off for a
timer recording
to take place!
Make sure there
is a tape in the
VCR.
Making Corrections
I. While the screen you want to change is
displayed, press the CLEAR button
until the cursor is flashing on the item
you want to change. Then enter the
correct information.
2. Continue to do this until all information
is correct.
3. Press the STATUS!EXIT button to exit.
Note: You can exit the Program
review at any time by pressing
the STATUS/EXIT button.
VCR
Timer
POWER
Button Light
POWER Button
i
MENU Button--
Number Buttons--
STATUS/EXIT
Button
CLEAR Button
tS®'_
{::_::_ c_
O0 OO
Remote Control
• CLASH mayflash on the screen
when you finish setting a timer
recording. This means that the
timer recording you just pro-
grammed and another timer record-
ing overlap, and thus the current
timer recording will not be carried
out. In this case, cancel one of the
overlapping timer recordings.
• If the preset time for a timer record-
ing comes up during an OTR, the
OTR has priority.
• To stop a started timer recording,
press the STOP/EJECT button on
the VCR.
• If the power fails for more than one
minute, programmed timer record-
ings will be lost. When you use the
VCR with the auto clock function set
to OFF, repeat the steps on page I0
before re-programming the timer
recordings.
Please see page 35 for more notes.