Filter
Top Products
4O
Before Requesting Service
ee ol • oe oe ooeoe eQ oe eo* ee eeoeoe ee ooe oeee eoeoe eeoe eoeo *eooe ee oo •eeoe eoete ee eeoeoe =eoeooeee oe oe eooe*e *oe eooe oeo ee oeQe le oee eeoe oe*oeoe ee
If you are having problems with your VCR, check the following list of problems and possible solutions before requesting service.
You may be able to solve the problem yourself.
Power
No power
Power failure
Recording/Playback
A TV program cannot be recorded.
The VCR will not perform a timer
recording.
There is no playback picture, or
the playback picture is noisy or
contains streaks.
During special effects playback,
the picture is noisy or contains
vertical jitter when using a TV
with an autnmatic vertical hold
control.
The top of the playback picture
waves back and forth excessively.
Remote Control
The VCR cannot be controlled with
the remote control.
The Number buttons won't work for
channels above 69.
(continued on page 41)
e
e
• Make sure the power plug is completely connected to an AC (alternating current) outlet.
• Make sure the power is turned on.
• When you use the VCR with auto clock function OFF, follow the steps on page
10 to reset the clock.
• Check the connections between the VCR, TV, and antenna/cable (page six).
• Make sure the band selected (VHF/UHF) matches your antenna/cable system.
• Make sure the tape has a record tab (page five).
• Make sure the recording start and stop times are set correctly (pages 20-25).
• Make sure a tape is in the VCR and the tape has a record tab (page five).
• Make sure the VCR power is off.
• Make sure the clock is set (pages 10-11).
• The VCR may not perform or continue a timer recording if a power interruption of
more than one minute occurs during the timer recording, even if the power comes
back on afterward.
• Make sure the TV is on the same channel as the VCR's CH3/CH4 switch (page six).
• Make sure the VCR is in VCR position (pages 13, 15-16).
• Make sure channel 3 or 4 is properly adjusted.
• Adjust the tracking (page 32).
Set the TV's vertical hold control to manual, then adjust (see notes on page 31).
• Because the VCR playback signal is not as stable as an off-the-air TV signal, the
top of the TV screen may waver during playback. To stop this, slowly turn the
horizontal hold control on the TV. If the TV does not have a horizontal hold con-
trol, or if adjusting the control does not help, contact your TV service center.
• Press the VCR button on the remote control, then try again.
• Aim the remote control directly at the VCR's remote sensor (page five).
• Remove all obstacles between the remote control and the VCR (page five).
• Inspect and/or replace the batteries in the remote control (page five).
• Select CABLE TV from the tuner set up display (page 27), then let the VCR
program the channels.
Periodic maintenance is required to maintain your VCR's continued excellent performance. Your VCR has an automatic head
cleaning system that helps prevent clogging of the video heads. Cleaning is performed each time you insert or remove a video cas-
sette. However, this feature is preventative only. If the video heads are very clogged, take your VCR to an authorized service center.