Filter
Top Products
3O
Playback Options (cont'd)
Time Counter Memory
Follow the steps below to reset the time
counter to zero at a tape location you want
to refer to later.
1
Play, fast forward, or rewind a tape to the
location that you would like to refer to later.
Press the STOP button or the STOP/EJECT
button to stop the tape.
2
Press the STATUS/EXIT button. The status
display will appear on-screen for about five
seconds.
3
While the status display is still on-screen,
press the CLEAR button to reset the time
counter to zero.
4
While the time counter is still on-screen,
press the MEMORY button to set the time
counter memory. M will appear to the left
of the time counter on-screen.
I M 0:00:00 1
5
To go to a tape location where the time
counter was reset to zero, press the
REW(ind)/SEARCH button or the
FF/SEARCH button when in Stop mode.
When the tape reaches the point at which the
time counter was reset to zero, the tape will
stop. Press the PLAY button to watch the
.. ( '-'-" ""' 1
k
VCR
1
Play, fast forward, or rewind a tape to the
location that you would like to refer to
later. Press the STOP button or the
STOP/EJECT button to stop the tape.
5
When in Stop mode,
press the
REW(ind)/SEARCH
button or the
FF/SEARCH button
to go to a tape loca-
tion where the time
counter was reset to
zero.
Press the
STATUS!EXIT_out -
ton to bring up the
status display.
)
Press the CLEAR but-
ton to reset the time
counter to zero.
Cc£z--6--c:_
03@@_
o c::D o-
0000(9-
O0 O0
Press the MEMORY
Remote Control button to set the time
counter merriory.
• • • •• .. ••• ••. • ••• •• ••• •• •• ••.•• •••• •••.• •• •o •. -. • ••• • i ••• •• •• • •- •• •• •• ••• •• ••" • ••
"1
i • The MEMORY button does not function during Repeat Playback. [
: • The VCR must be in Normal Play mode before you can set the Time Counter
: Memory. See Notes on page 29for details on putting the VCR in Normal Play
• mode.
! • To erase a 71me Counter Memory, press the MEMORY button twice. The M will
: disappear from the screen.
": • You may only set the time counter to zero at one location at a time. If you try to
set the time counter to zero at a second location, the previous time counter to
i zero setting will be erased.