Filter
Top Products
7
Turning on Your .VCR-
TV and VCR
CH3 [_ CH,
Press the VCR button,
then the POWER
button.
3y
Press the Number 1
button for English on-
screen displays or the
Number 2 button for
Spanish on-screen dis-
plays.
@_-
00000
O0 O0
1
Set the TV to channel
3 or 4, whichever
channel.the CH3/CH4
switch on the back of
the VCR is set to.
Remote
Control
-5
Press the CHANNEL
(Up) button.
-4
Press the MENU
button.
• If you do not see any on-screen displays when you turn on the VCR, repeat
the steps under "Hooking Up Your VCR" on page six, then try again. If
you still do not see any on-screen displays, follow the steps under "Channel
Memory" on page 27 and "Language Selection" on page 28.
• To skill this feature andplay a tape immediately, insert a tape with its
record tab removed. Playback will start immediately. Or, to skip step 3,
press the MENU button. All on-screen displays will be in English. To skip
step 5, press the STOP button. Channels will not be programmed, and
TUNER NOT SET will appear on-screen.
• To program channels or to change the language at a later time, follow the
steps on pages 27 and 28.
• lfyou try to program channels when there is no antenna or cable connected
to the VCR, programming will appear to take place, but eventually NO TV
SIGNALS will appear on-screen. Connect an antenna or cable to the VCR
and try again. You may need to follow the steps on page 27.
• You cannot program channels ifa cable converter box is connected to a
VCR that is connected to a TV. If you have this kind of connection, see
pages 36-39for details.
• Follow the steps on this page only when you plug the VCR power cord into
the wall outlet for the first time.
• The VCR distinguishes between standard TV channels and cable channels.
lf you change to TV or CABLE TV mode, follow the steps under "Channel
Memory" on page 27.
Before turning on your VCR, make sure
there are batteries in the remote control and
the VCR and TV are connected (see pages
five and six).
1
Turn the TV on. Set it to the same channel
as the CH3/CH4 switch on the back of the
VCR.
2
Press the VCR button, then the POWER
button. The VCR will come on and the lan-
guage select display screen shown below
will appear.
SELECTPUSH NO.SHOWN_
ENGLISH ON [
ESPNTX)L 1
E SELECTIONOR ]
H MENUTO CONTINUE)
3
Press the Number 1 button to select English
on-screen displays or the Number 2 button
to select Spanish on-screen displays.
4
Press the MENU button. The channel pro-
gram display shown below will appear. The
display will disappear after about 60 sec-
onds if you do not press any buttons.
_NECT ANTENNA OH CABL_
TOVCR /
THEN... l
PUSHOH UP KEY /
_O;LAY ONLY- PUSHSTOP_
5
i Press the CHANNEL (Up) button to begin
" automatic channel programming. AUTO
! SET PROCEEDING PLEASE WAIT will
appear on-screen. The VCR will place all
: of the channels you receive into its memo-
! ry, so when you scan through channels
using the CHANNEL (Up/Down) buttons,
i you'll only scan through channels that you
: receive. When all channels are pro-
i grammed, AUTO SET COMPLETED will
i appear on-screen briefly. Then the TV will
: go to the lowest channel programmed.