Filter
Top Products
PAGE 83
MS300 User’s Manual
Automatically Getting Disc Information
Once your changers are connected to the MS300 and loaded with CDs,
all you have to do is close the changer door and in a few seconds the
MS300 will begin looking up the disc information from each disc in
each changer.
Quick Lookup checks each previously empty slot in the changers to see
if any new discs were added, and then checks each previously occupied
slot in the changer to see if any discs were removed.
One by one, the Table of Contents is read from each CD and compared
to the local music database or the Gracenote® Music Recognition
Service using your Internet connection, as the MS300 builds your
Music Library. As each disc is accessed and looked up, the Quick
Lookup screen is updated to display the disc’s information and cover
art. When all of the discs are looked up, the Music Guide will be
displayed.
You can manually run Quick Lookup at any time by following
these steps:
1. Press the SETUP key on the remote to display the Setup menu.
2. Select the
CHANGER MANAGEMENT menu.
3. Select the LOOKUP DISCS
menu.
4. Select the
QUICK LOOKUP menu.
5. MS300 will perform a Quick Lookup for each new disc.
Warning: Quick Lookup checks for newly added and removed CDs each time it runs.
Do not remove CDs and replace new CDs into the same changer slots without running
Quick Lookup in-between, or the MS300 will not know that these slots have changed.
If you want to reuse the same slots, first remove your CDs, let Quick
Lookup run, then add new CDs to the same slots.
USER PREFERENCES