Mitsubishi Electronics X100 Projection Television User Manual


 
35
Super impose (Picture in Picture)
One of the special features of this unit is the picture-in-picture (PinP) mode. PinP allows you to view
different sources at the same time. The sub image will become a still picture.
1. Press the PinP button on the remote control. Pressing the PinP button repeatedly will select on
and off.
In PinP mode, the sound will be switched off.
When the main image is set to PC1 or PC2, the main and sub image will become still pictures.
When the main image and sub image are set to RGB1, RGB2, VIDEO1 or VIDEO2, the sub image
is recaptured by pressing the - button.
When the sub image is set to PC1 or PC2, the sub image is not recaptured by pressing the -
button.
The sub image may vibrate. If this is the case, select the image again by pressing the - button.
The super impose function wont work if there isnt an input signal.
You can change the input source, the frame position and the frame size by using the on-screen
menu.
You can change the input source of the PinP image by pressing the + button.
Pressing the ª or º buttons on the control panel (or { or } buttons on the remote control),
the main image will be in still mode and the sub image starts moving. Pressing the button again
will resume display.
In PinP mode you cannot adjust the zoom/focus.