Filter
Top Products
36
PC-CARD
The projector can record one frame at a time and play back an image by using the PC-CARD.
You can also play back the PC-CARD through the personal computer. See pages 39 - 41.
Using the PC-CARD
Use only the flash memory card of PCMCIA•ATA compatible type II.
• Due to PC-CARD type, some images can not be properly recorded.
• Before recording the images into the PC-CARD, prepare the group (GRP0) in the PC-CARD using
the attached utility software PCV (PC-CARD viewer).
Setting up / replacing the PC-CARD
1. Set the projector into standby mode by pressing the main power switch. The POWER indicator
lights up red.
2. Open PC-CARD cover on the left side of the projector.
3. To replace the card, press the eject button to take the card out.
4. Insert the card, making sure the direction of the card is correct.
The PC CARD indicator will be illuminated.
5. Close the cover.
When the input source is set to PC1 or PC2, or during recording to the PC card, do not remove the
PC card. The projector may not work correctly.
Emergency capture from projector source
1. Set the projector into standby mode by pressing the main power switch.
2. Turn on the equipment connected to the projector.
3. Insert the card
4. Turn the projector on by pressing the POWER button on the top control panel.
5. Select the desired external input source by using the SOURCE button.
6. Press the CAPTURE button, when the desired image is selected for recording.
The image will freeze.
7. Press and hold the CAPTURE button for about three seconds before releasing.
The projector displays a blue screen and a time gauge appears.
• The recording takes about two minutes.
• When the recording ends, the blue screen will disappear.
• During recording, none of the buttons would operate.
• During recording, do not push any buttons on the control panel, remote control, or PCGC.
• When the image is not recorded correctly, the message “WRITE NG!” is appeared on the screen.
In case the above happens, delete the incomplete file using the PCV software to obtain the
memory storage capacity of the PC card.
• To record one picture, the memory storage capacity of 2.4 MB is necessary. Please check for
free space on the PCMCIA CARD before recording.
• When there is not enough capacity left in PC-CARD, the message "WRITE NG!" will appear on
the screen. In this case, turn the projector off and change PC-CARD.
• The picture modified by keystone cannot be recorded correctly. Please set the KEYSTONE to
0˚ before recording.
• We recommend to use the CAPTURE button on the remote control.
• When using the CAPTURE button on the control panel, the projector may record repeatedly. In
this case, press the or buttons on the control panel (or $ or % buttons on the remote
control) when the image is frozen. Then the unit will not record repeatedly.
8. To record another image, repeat steps 6 and 7.
Play back
1. Insert the prerecorded PC-card.