Filter
Top Products
8
lamp lid
Caution:
Do not replace the lamp right after using
the projector. The lamp is very hot. Switch
the projector to stand-by mode, wait at least
120 seconds for the lamp and LCD panel to
cool. Then turn off the main power switch,
unplug from the outlet and wait for another
one hour or until the lamp is cool to the
touch.
control panel
handle
Hold here to carry this projector.
input source (input)
Use to select the input source you wish to watch.
See page 23.
power
Use to turn the projector on or off when MAIN POWER is on.
To turn the projector off, press this button twice. See page 22.
freeze / capture
Use to freeze the image. When the PC card is inserted, you can record the “freezed” image. Press one
time to freeze. For the second time hold for 5 seconds to record the image into the card. See page 36.
expand / PinP
Use to change the mode, EXPAND, NATIVE or PinP (Picture in Picture).
See pages 23, 34 & 35.
lamp indicator
This informs you of the status of the light source lamp and its service
life. When the projector lamp is lit, the indicator lights up in green.
This indicator blinks red when the service life of the lamp is about to
expire (about 1,000 hours). When the lamp is used up to 1,300 hours,
the projector automatically shuts off. See pages 22 & 49.
The projector automatically shuts off when
the lamp is used up in about 1,300 hours and
not used until lamp replacement.
temperature indicator
This informs you of the thermal condition inside the projector. When
the inside temperature is extremely high, the power automatically
shuts off while the indicator blinks red. See page 49.
power indicator
When the main power switch is on in stand-by
mode, this indicator lights up red. When the
projector is fully "ON", the indicator lights up
green. See pages 22 & 49.
exhaust slits
LAMP
SOURCE
FREEZE
/CAPTURE
EXPAND
/PinP
TEMP
Overview of the projector