Mitsubishi Electronics X100 Projection Television User Manual


 
52
PROBLEMS CAUSE
POSSIBLE SOLUTIONS
The image
remains blurred.
When you see the stationary image for a long time, it may remain on the screen if
you change the image. It is not a breakdown. The blurred image will disappear in a
few minutes.
Red, blue or green
dots are viewed on
the text of image.
It is normal.
The image is
distorted on the
screen and
noise is heard.
No sound is
heard.
Volume is not turned up.
Mute function on PCGC is on.
Connection to other equipment is not
made correctly.
Turn up the volume.
Cancel the mute function. See page 30.
Check connections.
See page 21.
Nothing is
displayed on
the PC monitor.
The PC monitor is not turned on.
Turn on the monitor.
Warm air comes out
of the exhaust vents.
This is typical of the LCD projector.
Adjustments cannot
be made.
The operation is incorrectly made due
to noise or interference.
Reset the mode and try again.
The cable for connection with other
equipment is not plugged securely
into the terminal.
The projector is installed too close to
other equipment.
Plug the connecting cable securely into the
terminal. See pages 17-21.
Install the projector far away from other
equipment.