Filter
Top Products
19
English
INTRODUCTION
PREPARATION WATCHING TV
USING FUNCTIONS
OPERATING DVD
CONNECTING DEVICES
INFORMATION USEFUL TIPS
Channel
Before you begin:
Make sure the unit is connected to antenna or cable.
1 Use ▲/▼ to select the item you want to adjust, then press
ENTER.
Picture
Sound
Channel
Features
Language
DVD
Channel
Autoprogram
Channel List
Add Channels
Antenna
2 Adjust the following items.
Autoprogram
If you switch wires (e.g. between antenna and CATV) or if you
move the unit to a different area after the initial setting, or if
you restore the DTV channels you deleted, it is recommended
to use Autoprogram to perform a new channel search.
1 Use ▲/▼ to select [Autoprogram], then press ENTER.
2 Use ▲/▼ to select an appropriate option, then press
ENTER.
Picture
Sound
Channel
Features
Language
DVD
Autoprogram
Auto program will rescan all channels.
Auto programming may take more than 20
minutes to complete.
Select your signal source.
ANT.IN
Antenna
Cable
Or
Back
Antenna
Cable
• When connected to VHF / UHF antenna, select [Antenna].
• When connected to CATV, select [Cable].
• [Autoprogram] will begin.
Please wait while the system is scanning for channels.
Auto programming may take more than 20 minutes to
complete.
75%
Digital channels
10 ch
Analog channels
6 ch
Exit
• When the scanning and memorizing are completed, the
lowest memorized channel will be displayed.
Note
• After setting [Autoprogram], using CH ▲/▼ on the remote
control skips unavailable programs automatically.
• If you are not receiving a signal from your cable service, contact
the Cable provider.
• If you press POWER or SETUP during autoprogram, the setting
will be canceled.
• Even if [Autoprogram] is completed, the channel setting will be
lost if the AC power cord is unplugged before the unit goes into
standby mode by pressing POWER.
• The PIN code will be required once you set a PIN code in the
[Child Lock].
➠
p. 21
• If you want to change your PIN code, follow the instruction of
[Change PIN].
➠
p. 23
Channel List
The channels selected here can be skipped when selecting the
channels using CH ▲/▼.
Those channels can still be selected with the Number buttons.
1 Use ▲/▼ to select [Channel List], then press ENTER.
2 Use ▲/▼ to select the channel you want to remove, then
press ENTER.
Picture
Sound
Channel
Features
Language
DVD
Channel List
Highlight channels for
Ch Up / Down key selection.
DTV 6-1
DTV 8-1
9
27
DTV 48-1
58
DTV 67-1
Ch Select
ENTER
Watch / Skip Back
• The channel display for the removed channel darkens.
You will not be able to select the channel again using
CH ▲/▼.
• To reactivate a removed channel, use ▲/▼ and press
ENTER. The registered channels are highlighted.
• When you remove a main channel, its subchannels are
removed as well.
Note
• The channel with the [DTV] indicated on the display is ATSC.
Otherwise the channel is NTSC.