Filter
Top Products
23
RQT8857
[RAM] [-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW] [VHS]
Manual Recording
Preparation:
]RAM\ If the disc is protected, release protection
(¼ 56).
[VHS] Ensure accidental erasure tab is intact.
Connect a satellite receiver to this unit’s input
terminals (¼ 9).
When the output signal from the external equipment
is NTSC, change the “TV System” to “NTSC” in the
Setup menu (¼ 63).
With the unit stopped.
SELECT
INPUT
to select “AV2” for the
satellite receiver you have
connected.
Select the channel on the satellite
receiver.
REC MODE
to select the recording
mode.
Tips
To skip unwanted parts
Press [PAUSE] to pause recording. (Press again to restart
recording.)
To stop recording
Press [STOP].
Linked timer recordings with external
equipment (SKY Digital STB/satellite
receiver) — EXT LINK
Preparation:
]RAM\ If the disc is protected, release protection
(¼ 56).
[VHS] Ensure accidental erasure tab is intact.
Make sure you connect the AV2 input terminal of
this unit to “VCR Scart Terminal” of a SKY Digital
STB/satellite receiver with a 21-pin scart cable
(¼ 9).
Set the “AV2 Input” and “Ext Link” to match the
connected equipment in the Setup menu (¼ 63).
Make timer programming on SKY
Digital STB/satellite receiver.
−
Refer to the equipment’s operating instructions.
Tips
To cancel the external control
Press [EXT LINK] to stop recording or to cancel linked timer
recording standby (The unit turns on and ‘‘EXT-L” disappears.).
Manual timer recordings (¼ 26)
Notes
In order to prevent accidental operation, press [EXT LINK] to
cancel the setting after recording is fi nished.
This function does not work with some equipment. Refer to the
equipment’s operating instructions.
The beginnings of recordings may not be recorded correctly in
some cases.
When “Ext Link” is set to “Ext Link 2”, this function does not work
if the input signal is NTSC system.
Programmes are recorded as one title on this unit when the end
time of the earlier timer recording and the start time of the later
timer recording are close to each other.
[RAM] To divide the titles, go to “Divide Title” (¼ 46).
While the unit is in EXT LINK standby mode or recording, video
picture is from the AV2 input terminal irrespective of “AV1 Output”
setting (¼ 63).
REC
to start recording.
To record programmes from a SKY Digital STB/satellite
receiver using timer programming
EXT LINK
− The unit turns off and “EXT-L” lights on the
unit’s display to indicate timer recording
standby has been activated.
− While the unit is in EXT LINK standby mode
or recording, most operations on this unit are
prohibited ([ OPEN/CLOSE], [/l] etc.).
When you operate, press [EXT LINK] to
cancel EXT LINK standby mode or recording
(The unit turns on and “EXT-L” disappears.).
Recording from a Satellite Receiver
Advanced FeaturesAdvanced Features
DRIVE
SELECT
to select the DVD or VHS
drive.
– Insert a disc or video cassette with enough
remaining blank space (¼ 72, 74).
DRIVE
SELECT
to select the DVD or VHS
drive.
– Insert a disc or video cassette with enough
remaining blank space (¼ 72, 74).