Filter
Top Products
79
RQT8857
Page
General Issues DVB-T (Continued)
Unusual station sorting.
The station sorting of this unit is pre-defined. Use profiles to sort the
stations as you want them.
58
The digital channel information
does not appear.
Select the length of time (3–10 sec.) in the “On-Screen Messages” in the
Setup menu.
62
The digital channel information will not appear during playback or
recording.
−
No Digital TEXT
When subtitle is on or additional information in the digital channel
informaion is displayed, Digital Text does not work.
−
After the auto setup, there aren’t
any stations in the station list
although found stations were
displayed during auto setup.
“Shipping Condition” was performed or the unit was in the delivery status.
The auto setup was then started and interrupted.
Do an auto setup again and let it continue right through to the end.
The data is only saved after this has been completed.
−
The Signal Strength is over 100%
(> 10)
Reduce the signal amplification at your aerial.
59
Poor picture in spite of good signal
quality.
Overmodulation makes the signal strength display go to red.
Readjust the picture with your room aerial until the picture quality
improves.
−
Page
General Issues VIERA Link
VIERA Link doesn’t work.
Check the HDMI cable connection. Check that “HDMI” is displayed on the
front display when the power for the main unit is set to On.
Make sure that “VIERA Link” is set to “On”.
Check the “HDAVI Control” settings on the connected device.
If the connection for the equipment connected with an HDMI cable was
changed, or if there was a power failure or the plug was removed from
the household mains socket, “HDAVI Control” may not work. In this case,
perform the following operations.
1. When the HDMI cable is connected to all equipment with the power on,
turn the TV (VIERA) on again.
2. Change the TV (VIERA) settings for the “HDAVI Control” function to
off, and then set to on again. (For more information, see the VIERA
operating instructions.)
3. Switch the VIERA input to HDMI connection with this unit, and after this
unit’s screen is displayed, check that “HDAVI Control” is working.
−
63
−
−
The control panel does not appear.
The control panel is only displayed when connected to a TV with “HDAVI
Control 2” function.
43
Reference