Filter
Top Products
56
Tape Trade Editing
When performing a Programme Editing after this VCR and Panasonic Digital Video Camera have been connected
using an Edit cable and a DV cable (cable for sending video and audio signals), this function enables the Editing
controller of this VCR to set the edit points for the playback unit.
It makes it easy to accomplish those operations using the Jog/Shuttle functions, which are so crucial for setting the
edit points, with the same operational “feel” of the operating the playback unit without depending on the playback unit
operations.
Settings for the tape in the playback unit
1 Insert the tape to be used for the playback unit in this
VCR, and set the switches as shown below.
2 Register the playback unit’s editing programmes.
(Refer to the procedure for Programme Editing on
pages 46 to 51.)
3 Remove the tape to be used for the playback unit from
this VCR, and insert it in the playback unit.
(Leave the playback unit in the playback mode.)
Settings for the tape in the recording unit
4 Insert the tape to be used for the recording VCR, and
set the switches as shown below.
5 Register the recording VCR’s editing programmes.
(Refer to the procedure for Programme Editing on
pages 46 to 51.)
6 Editing the registered programmes. (Refer to the
procedure for Programme Editing on pages 46 to
51.)
Note:
≥ This function cannot be used for editing operations
involving AV Insert, Audio Dubbing or Audio
Mixing.
S-VIDEO
VIDEO
L– AUDIO – R
S-VIDEO
VIDEO
L/MONO– AUDIO – R
Í / I <
EJECT
AUDIO
OUT
REW STOP
PLAY
FF PAUSE
STEREO
SERECT
DV2
DV SELECT
1
2
EDIT 8mm
¥
AV4
OUT
AV4
IN
EDIT CONTROL
RECORDER
PRINTER/
D.STILL PICTURE
PLAYER
PASSIVE
EDIT
DV
8mm
SP/LP TBC 3D DNR PRINT
AUDIO REC LEVEL
AUDIO MIX
STILL
ALBUM
INPUT SELECT
010
STEREO1
STEREO1 STEREO2
100
¥
REC
/
OTR
MIXING EDIT
EDIT CONTROL
RECORDER
PRINTER/
D.STILL PICTURE
PLAYER
PASSIVE
EDIT
DV
8mm
EDIT CONTROL
RECORDER
PRINTER/
D.STILL PICTURE
PLAYER
PASSIVE
EDIT
DV
8mm
Preparation
≥ Complete necessary connections and settings.