Panasonic WV-CU360C Home Theater Server User Manual


 
72
Controller Number Setting
Set this switch always to 1 when using the System
Controller in a System 850.
Switch Setting Procedures
Set the MODE DIP switch and CONTROLLER NO. switch as
follows.
1. Remove the DC plug from the rear of the controller.
2. Set the switches as follows.
Bit 1 should be set to OFF*.
Bit 2 should be set to ON.
Bit 3 should be set to OFF*.
Bit 4 should be set to OFF*.
Bit 5 should be set to ON* when connecting with a
System 850 in a home run (one to one) fashion.
Bit 6 should be set to OFF* (Operator) normally, or ON
(Administrator) when setting up the controller.
Bit 7 should be set to ON. The baud rate is selected in
the controller setup.
Bit 8 should be set to OFF* normally.
3. Connect the DC plug to the controller.
SW position
OFF
See below
See below
See below
Not used
On*
Administrator
Set up from CU360
3 times
Function
ON
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Bit 8
System ID
System ID
System ID
Reserved
Line termination
Operation mode
Baud Rate Selection
Repeat Transmissions
*
*
*
*
Off
Operator*
Auto-selection*
1 time*
MODE
12345678
OFF
ON
0
9
8
7
6
5
4
3
2
1
CONTROLLER No.
DIP Switch Setting
An 8-bit DIP switch mounted on the rear panel specifies communication mode, etc. The default position is marked with an
asterisk *.
DC 9V IN
DATAMODECONTROLLER No.
0
9
8
7
6
5
4
3
2
1