75
OPERATING PROCEDURES (For System 850)
■ Login & Logout
● Login
1. Turn on the power switches of all system components.
2. Turn on the power of the WV-CU360C System Controller
by connecting the AC adapter to the AC outlet.
The OPERATE indicator lights up and “NO USER” will
appear on the LED display of the System Controller.
3. Enter your registered Operator ID number (up to 5 dig-
its) using the numeric buttons, then press the [CAM-
ERA (ENTER)] button. The underline appears on the
LED display.
4. Enter your registered Password (up to 5 digits) using
the numeric buttons, then press the [CAMERA
(ENTER)] button.
If the operator ID and password entered are valid, the
LED will display “READY”.
Note: If login has failed (operator or password error), the
PROHIBITED indicator on the controller will light up and
“NO ACCESS” will blink on the LED display for about 3
seconds. Then the login procedure returns to the start.
● Logout
1. While holding down the LOG OUT button, press the
[CAMERA (ENTER)] button .
“NO USER” is displayed on the LED display.
PROGRAM
PRESET
CALL
PRESET
AUX1 OFF
CAM ID
AUX1 ON
GEN
WIPER
AUX2 OFF
MON STATUS
AUX2 ON
ALL
SHIFT
CLEAR
(
ESC
)
DEF OFF DEF ON
CAMERA
(
ENTER
)
AUTO
PA N
123
456
78
0
9
PROGRAM
PRESET
CALL
PRESET
AUX1 OFF
CAM ID
AUX1 ON
GEN
WIPER
AUX2 OFF
MON STATUS
AUX2 ON
ALL
SHIFT
CLEAR
(
ESC
)
DEF OFF DEF ON
CAMERA
(
ENTER
)
AUTO
PA N
123
456
78
0
9
LOG OUT
CAMERA
(ENTER)
AUTO
PAN
Note: This section describes only some important operations such as login, logout, and different operations from the front
panel of the System 850. Please refer to the manual included with the System 850 for further information on camera
selection, monitor selection and so forth.