73
SETUP PROCEDURES (For System 850)
To display the setup menus for the WV-CU360C System Controller on the LED display, set the MODE switch and power up the
controller as described below.
■ Prior to Setup
Do the following before entering the setup mode.
1. Confirm that all necessary connections and switch set-
tings are complete.
2. With the power turned off, move bit #6 of the MODE
switch on the rear to ON (administrator) position.
3. Supply power to the controller.
4. Turn on the power of cameras and other system units.
5. The LCD displays [SEtUP]. The controller is ready to
enter the setup mode.
When setup is completed, restore the switch to its original
position.
1. With the power turned off, move bit #6 of the MODE
switch on the rear to OFF (operator) position.
2. Supply the power to the controller.
■ Buttons and Controls used for Setup
The following buttons and joystick operations are used for
setup.
DC 9V IN
MODE
12345678
OFF
ON
MODE
12345678
OFF
ON
Operator mode
Administrator mode
0
9
Numeric buttons: To select a parameter
CAM (ENTER) button: To execute modes
and parameters
To enter a submenu
CLEAR (ESC) button: To return to the previ-
ous menu
CAMERA
(ENTER)
AUTO
PA N
DOWN
LR
UP
LR
UP
DOWN
R
UP
DOWN
LR
Up: To select a setup menu
Down: To select a setup menu
Left: To decrease the parameter
Right: To increase the parameter
CLEAR
(ESC)
EXIT