Filter
Top Products
34
Setup
This section explains preparations for recording - setting up the DVD Video Camera and battery pack.
Setting Up the DVD Video Camera
Holding DVD Video Camera
Using Grip Belt
Insert your right hand from the bottom of
DVD Video Camera up to the base of your
thumb.
Put your hand in a position where you can
easily operate the REC button, Photo
shot button, and the Zoom lever.
Adjust the length of grip belt so that the
DVD Video Camera is stable when you
press the REC button with your thumb.
1)Detach the belt.
2)Ajust the length of grip belt.
3)Attach the belt.
Note:
Do not adjust the grip belt while holding the DVD Video Camera: Doing this could cause the DVD Video Camera to fall
and be damaged.
To use as a Hand Strap (Only for VDR-M95PP)
Using the Grip Belt as a hand strap makes it easier to carry the DVD Video Camera.
1 Detach the Grip Belt from the Video Camera.
1) Open the Lock cover.
2) Push the Lock button and pull the grip belt
from the DVD Video Camera.
Support the DVD Video Camera securely by
the hand to avoid falling.
2 Make it a hand strap.
1) Turn over the belt.
2) Pull the tip in the derection of the
arrow.
3) Attach the belt.
• VDR-M95PP
• VDR-M53PP/VDR-M55PP/VDR-M75PP
Lock cover
Lock cover
Lock button
Open the lock cover while pinching the protection
portion of both ends.
Return the lock cover to the closed position
after pulling out the grip belt.
VDR-M95M75M55M53PP.book Page 34 Tuesday, March 29, 2005 2:19 PM