Filter
Top Products
69
13
Setting Flash
(See “Introduction to Optional Accessories” on page 145)
When shooting stills, you can use the optional VW-
FLH3
*1
Flash (P. 145). Refer to the Flash manual for
instructions.
*
1
Only for VDR-M75PP/VDR-M95PP
*
2
Without light emission, the “ A” display is cleared
when you press the Photo shot button halfway.
When using the flash, if you press the Photo shot
button half-way the indication will change to “ ”.
Note:
• The DVD Video Camera automatically sets the shutter
speed between 1/800 and 1/30 second (between 1/800
and 1/10 second if Program AE has been set to Low
Light) depending on subject brightness (
P. 80 ).
• The available range of the Flash is about
1 - 4 m.
• See “Switching Quality of Still Image (Quality)” on
page 85 if you want to change the still quality mode.
• Dark subjects may not be in clear focus even if the Flash
is used. It is recommended that you illuminate a subject
when recording in a dark place.
• When you use accessories for hot shoe (only optional
VW-FLH3), the power is supplied by this DVD Video
Camera. (Only for VDR-M75PP/VDR-M95PP.)
• The built-in flash cannot be used together with the
separately sold Flash.
• If a separately sold Flash is connected, it is given priority.
(Only VDR-M95PP.)
Setting of
Flash
On-screen
information
Manner of
emitting light
AUTO
A*
2
Automatically
emits light in dark
place or in a place
lit from rear.
ON Always emits light
regardless of
brightness.
OFF No light emission.
VDR-M95M75M55M53PP.book Page 69 Tuesday, March 29, 2005 2:19 PM