Filter
Top Products
Planning the installation 17
SmartNode 10200 Series User Manual 2 • Hardware Installation
Planning the installation
Supplies
In the SN10200 box, you will find:
• One SN10200
• One set of mounting brackets with screws. These are used for mounting a SN10200 on a 19” rack.
• One DB-9 to RJ-45 adapter. Allows you to interface the serial port of your computer with the RJ-45 con-
sole port of the SN10200.
• SCSI cables and patch panels. This is optional and only provided for the SN10200-xxE models, which fea-
ture SCSI connectors.
• Three CAT5 Ethernet straight cables (male-male), three meters in length.
• One warranty sheet
• One packing slip
• One SN10200 Quick Start guide
Not included with the SN10200:
• No power cords are supplied for AC units. Two DC power cables are included with DC units.
• A 19” equipment rack. You must use a standard 19” wide equipment rack to install the SN10200.
Procedures
To install the SmartNode 10200, follow these steps:
1. Mount the SmartNode 10200 on an equipment rack (See “Mounting the SN10200 to a rack” on page 18)
2. Connect the management interface (See “Connecting the management interface” on page 19)
3. Connect the VoIP ports to the network (See “Connecting to a VoIP network” on page 21)
4. Connect the correct interfaces to the PSTN (See “Connecting to the PSTN” on page 22)
5. Connect to the power source (See “Connecting power” on page 26)