Filter
Top Products
Accessing the SN10200 33
SmartNode 10200 Series User Manual 3 • Initial Setup and Web Management
Accessing the SmartNode via the Ethernet Management port
The SN10200 is shipped with the SN-CTRL pre-installed. In order to make changes to the system configura-
tion, you must connect to the Management port labeled Ethernet on the front of the SN10200 to a terminal.
To access the SN10200, you must use an SSH connection. The password is set at the factory and is indicated
on the shipment sheet.
Figure 11. SN10200 Ethernet Management Interface
SmartNode
™
Console
Ethernet
Power
TDM+VoIP Smart Media Gateway
Management
Ethernet
Management Port