Filter
Top Products
Working with Configurations 42
SmartNode 10200 Series User Manual 3 • Initial Setup and Web Management
Starting an Application
In order to be able to load and start an application, it will need to have been installed on the Smart Media
application server. In addition, at least one Smart Media unit must have been configured on the Smart Media
application server so that you are able to connect to it.
When you first log on to the Web Portal, your system application will have been installed on the Smart Media
application server, and it will be in a management state. This means that the application is not yet operating
and controlling your system. In order to start an application, its state must be changed from Management to
Run. To start an application:
1. Select Instances from the navigation panel.
2. Select the application that you wish to run and click Edit.
Figure 29. Application Instance List > Edit
3. Click the Status tab to activate the application.
Figure 30. Application Status
4. Set the Oam target state to Run.
5. Click Apply States.
Figure 31. Apply States