Filter
Top Products
Connecting power 28
SmartNode 10200 Series User Manual 2 • Hardware Installation
Powering Down
Powering down the SN10200 requires that the Linux embedded host be shut down. In order to do this, you
must connect to the management interface using SSH, and enter:
shutdown -hp now
DO NOT TURN OFF the power to the SN10200 using the
power switch located at the rear, unless the Linux host has been
properly shut down beforehand, using the reset button display, or
manually using the shutdown command.
Allow enough time for the Linux host to shut down before turning
the power to the SN10200 off (e.g. 1 min). Be aware that the
shutdown procedure of the unit is logged and traceable for sup-
port and warranty purposes.