Filter
Top Products
Mechanical Instructions
Rear Cover Removal
1. Removeall fixation screws of the rear cover.
2. Now pull the rear cover backward to remove it.
Service Position Main Panel
There are 2 configurations. With and withoutpanel bracket. Both have a different service
position:
Main panel without bracket.
1. Disconnectthe strain relief of the AC power cord.
2. Remove the main panel, by pushing the two centerclips outward [1]. At the same time
pull the panelaway from the CRT [2].
3. Disconnect the degaussing coil by removing thecable from (red) connector 0201.
4. Turn the panel 90 degrees counter clockwise [3].
5. Flip the panel 90 degrees [4],with the components towards the CRT.
6. Turn the panel with the rear I/O towardsthe CRT [5].
7. Slide the metal heatsink (near the mains transformer5520) underneath the right chassis
bracket, so the panel is secured [6].
Pa
g
e 1 of 7SPMS
7/8/2004