Filter
Top Products
Recording
05
41
En
4 Select ‘Store Program’ to finish.
• Other options in the same menu panel allow you to
name the program, and change the recording
destination and/or recording mode.
G-Code programming with the power off
You can enter a G-Code programming number when the
recorder is in standby.
Note that the recording is always made to the HDD. If you
want to record to a DVD disc, you’ll need to switch on the
power and use the full G-Code program screen.
Important
• You can’t use this feature until you have set up the
guide channels. See
G-Code CH Setting
on page 93.
• You can’t change the recording mode.
• You can’t program daily or weekly timer recordings.
1 Press ’G-Code’.
The front panel display shows the current recording
mode and prompts you to enter the G-Code programming
number.
2 Use the number buttons to enter the number.
• To clear the last digit entered, press
CLEAR
.
3 Press ENTER.
The display shows the timer settings:
Date
Start time
End time
HDD and Recording
channel
Recording mode.
• If
CODE ERROR
appears in the display, check that
the number is correct and that the guide channel is
set (see
G-Code CH Setting
on page 93), then set the
timer recording again.
• If
CAN’T SET
appears in the display, it means that
although you entered a valid number, the program
has already finished.
Setting a manual timer recording
The timer recording screen you can see all the timer
programs already set, clear programs and set up new
ones.
1 Press TIMER REC to display the Timer Recording
screen.
You can also access the Timer Recording screen from
the Home Menu (press
HOME MENU
, select
Timer
Recording
, then
Timer Recording
).
This screen shows all the timer programs currently set.
• Each row is for one timer recording program, with the
date and time information, channel, recording mode,
DVD or HDD and recording status.
• The amount of free space available on the HDD and
the currently loaded recordable DVD is shown
towards the bottom of the screen.
• In the upper-right corner, the number of timer
programs already set is shown next to
Tmr Pgms
.
• If there are more than five timer programs already
set, press
NEXT
to switch page (go back using
the
PREV
button).
• You can also delete a timer program before it’s
started (before the recorder enters timer recording
standby) by highlighting it and pressing
CLEAR
. See
also
Deleting a timer program
on page 43.
HDD DVD
CLEAR
ENTER
CLEAR
CH
G
-CODE
+
HOME
MENU
CLEAR
ENTER
CLEAR
PREV NEXT
TIMER REC
HDD Remain
DVD Remain
59h59m(SP)
1h59m(SP)
SAT 26/3 15:00
Tmr Pgms 4/32
Manhattan Open Tennis OK
SAT 26/3 18:00 – 21:00 Pr 10
World Journey OK
SUN 27/3 19:30 – 21:00 Pr 4
Flower Until 30/4
MON – FRI 13:30 – 14:00 Pr 8
New Input
Timer Program View
DVR630HS_RL.book 41 ページ ２００５年３月１８日 金曜日 午前９時４９分