The Initial Setup menu
13
92
En
Chapter 13
The Initial Setup menu
Using the Initial Setup menu
The Initial Setup menu is where you can set various recorder options for sound, picture, language and so on.
Some settings can only be changed when the recorder is stopped. During playback and recording these settings are
grayed out in the Initial Setup menu.
Except for the Setup Navigator, menu screens are exited automatically after 20 minutes of inactivity.
• Press HOME MENU and select ‘Initial Setup’.
In the table below, the default option is marked with a •.
Tip
• Some of the Initial Setup menu screens shown in this section vary slightly depending on the country or region of
purchase.
Setting
Options Explanation
Basic Settings
Clock Setting Auto
Set the channel that broadcasts a clock signal and the clock will be set
automatically.
Manual •
If there is no channel that broadcasts a clock signal in your area, you
can set the time and date manually.
Display
Set preferences for time and date display format.
The clock must be set in order to use timer recording.
Input Line System 525 System
Use for NTSC or PAL-60 recording from an external input.
625 System •
Use for standard PAL or SECAM recording.
See also About the input line system on page 98 for more information on this setting.
Power Save On
No antenna input signals are passed through to the outputs when the
recorder is in standby.
Off •
When the recorder is in standby, all signals arriving at the antenna
inputs are passed along to the outputs.
Help Setting On •
Switches on the automatic Help screens for GUI displays.
Off
Switches off the automatic Help screens for GUI displays. (Press
HELP
on the remote to manually display the Help screen.)
Setup Navigator Start
Select to start the Setup Navigator. See also
Switching on and setting
up
on page 24
.
DVR630HS_RL.book 92 ページ 2005年3月18日 金曜日 午前9時49分