Filter
Top Products
Recording
41
En
05
3 Confirm that the settings are correct.
If the channel number isn’t displayed, use
the / buttons to highlight CH, then use
the / buttons to set the correct channel
number.
• If the channel number is set, but
incorrectly, set up the guide channel
(see G-Code CH Setting on page 109).
4 Select ‘Store Programme’ to finish.
• Other options in the same menu panel
allow you to name the programme, and
change the recording destination and/or
recording mode.
Checking/editing timer recording
settings
You can check and/or edit the timer
recording settings made by the G-Code
system by selecting Details from the
G-Code# setting screen.
1 Select ‘Details’ from the
G-Code# setting screen.
The Timer Programme Set screen appears,
filled out with the timer recording details.
2 Check and edit the fields as
necessary.
See Setting a manual timer recording on
page 42 for more on this.
3 Select ‘Store Programme’ to
save the timer programme and exit.
G-Code programming with the
power off
You can enter a G-Code programming
number when the recorder is in standby.
Note that the recording is always made to
the HDD. If you want to record to a DVD disc,
you’ll need to switch on the power and use
the full G-Code programme screen.
Important
• You can’t use this feature until you have
set up the guide channels, see G-Code
CH Setting on page 109.
• You can’t change the recording mode.
• You can’t program daily or weekly timer
recordings.
1 Press ‘G-Code’.
The front panel display shows the current
recording mode and prompts you to enter
the G-Code programming number.
2 Use the number buttons to enter the
number.
• To clear the last digit entered, press
CLEAR.
3 Press ENTER.
The display shows the timer settings:
Date Start time End time HDD and
Recording channel Recording mode
•If CODE ERROR appears in the display,
check that the number is correct and
that the guide channel is set (see G-Code
CH Setting on page 109), then set the
timer recording again.
•If CAN’T SET appears in the display, it
means that although you entered a valid
number, the programme has already
finished.
ENTER
ENTER
DVRLX70_TF_EN.book 41 ページ ２００７年８月１日 水曜日 午後４時１４分