Filter
Top Products
Playing and recording from a DV camcorder
07
64
En
Chapter 7
Playing and recording from a
DV camcorder
You can play back and record video from a
DV camcorder connected to the DV IN jack
on the front panel of this recorder.
Important
• If you connect a second recorder using a
DV cable, you cannot control the second
unit from this one.
• You can’t control this unit remotely from
a component connected to the DV IN
jack.
Playing from a DV camcorder
1 Make sure your DV camcorder is
connected to the front panel DV IN jack.
2 From the Initial Setup menu, check
that the DV audio input is setup as you
would like.
See DV Input on page 111 for more on this.
• Check also that the
Audio In
settings for
External Audio
and
Dual Mono
Recording/Bilingual Recording
are as
you want them (see Audio In on
page 110).
3 Select ‘DV’, then ‘DV Video
Playback’ from the Home Menu.
4 Start playback on the camcorder.
Images from the camcorder should appear
on your TV.
• To record the incoming video, use the
HDD and DVD button to select the HDD
or a DVD for recording, then press
REC. Press
F STOP REC to finish
recording. If there is no signal from the
device connected to the DV jack, or the
signal is copy-protected, recording will
pause. It will automatically restart once
there is a recordable signal.
• The recorder will only start recording
from the DV IN jack if there is a valid
signal. Recording will pause if the signal
is interrupted during recording.
• If your source is copy-protected using
Copy Guard, you will not be able to
record it. See Restrictions on video
recording on page 34 for more details.
Recording from a DV
camcorder
• The source signal must be DVC-SD
format.
• You can’t record date and time
information from DV cassette.
• During DV recording, if a part of the tape
is blank, or has copy-protected material
on it, this recorder will pause recording.
Recording will restart automatically
when there is a recordable signal.
However, if there is more than two
minutes of blank tape, this recorder will
stop recording and the camcorder
should stop (depending on the
camcorder).
Copying from a DV source
Using the recorder’s remote, you can control
both the camcorder and this recorder.
Important
• Some camcorders cannot be controlled
using this recorder’s remote.
• For best results when recording from a
DV camcorder to this recorder, we
recommend cueing the camcorder to
the place you want to start recording
from and setting the camcorder to
play-pause.
HOME
MENU
DVRLX70_TF_EN.book 64 ページ ２００７年８月１日 水曜日 午後４時１４分