Filter
Top Products
Connections & Setup
16 Chapter 1
Place Batteries in the Remote
Control
Follow these steps whenever you need to install or change the batteries in
your digital satellite receiver’s remote control.
Note: When replacing old batteries, you may need to reprogram the
remote control to operate other devices.
1. Remove the cover from the battery compartment.
2. Insert batteries in the battery compartment, matching
the + and – end of each battery.
3. Replace the cover.
Plug in and Turn on the Receiver
Plug the end of the power cord into the wall outlet. Be sure to insert the plug
completely.
To turn on the satellite receiver, press the SAT button on the remote control or
the ON•OFF button on the front panel. If your TV brand is RCA, GE, or
Proscan, press the TV button on the remote control to turn on the TV. If your
TV brand is not RCA, GE, or Proscan, see page 23 in the next section, Using
the Remote Control, for details on programming the satellite receiver’s remote
control to operate your TV.