Filter
Top Products
12 RR-1060
Folding Cover
A folding cover conceals the buttons at the bot-
tom of the RR-1060. These buttons provide extra
command functions. Leave the folding cover in
the closed position to simplify the RR-1060 for
routine use. Open the cover to access the addi-
tional buttons.
Device/Input Buttons
Two rows of buttons on the folding cover (AUD,
CD, TUN, TAPE, EXT and V1–V5) are used to se-
lect a component for control by the remote and,
if desired, to activate the input for the component
you are operating. How long the button is pressed
determines whether a device is selected just for
control by the remote or whether that input on
the A/V receiver or surround sound processor
is also activated.
To change the remote DEVICE only, press
the button briefly (less than one second). This
does not change the input selection.
To change the remote DEVICE and the in-
put selection on the A/V receiver, press and
hold the button for more than one second.
When a DEVICE/INPUT button is pressed, the
label for that button appears in the LCD display.
These labels can be customized, if desired. See
the Labeling DEVICE/INPUT Buttons section of
the manual for instructions.
The AUD button is pre-programmed to operate Ro-
tel A/V receivers and surround sound processors.
The V1 button is pre-programmed to operate Rotel
DVD players. The CD button is pre-programmed
to operate Rotel CD players.All other buttons are
unprogrammed and can be used to learn the con-
trol codes of other remote controls.
The control codes of the AUD and V1 buttons can
also be reprogrammed for other control codes.
If you do so, you can restore the original Rotel
control codes for these buttons. See the Restoring
Factory Defaults section of this manual.
NOTE: The DEVICE/INPUT buttons are also used
in programming the RR-1060 and are available
for storing and sending Smart Macros (automatic
sequences of up to 20 learned commands).