Filter
Top Products
26 RR-1060
7. A confirmation appears in the LCD. Use the
UP/DOWN buttons to select either YES (to
change the command) or NO (to discard the
changes). Press ENT to confirm.
NOTE: If you attempt to change an unprogrammed
Smart Macro button, the word EMPTY appears
and the remote returns to normal mode.
Clearing learned commands
You can clear a single learned command, a multi-
step command, all of the learned commands for a
single DEVICE/INPUT button, or all of the learned
commands for all DEVICE/INPUT buttons:
Clearing a Single Learned Command
1. Press the DEVICE/INPUT button where the
learned command is stored.
2. Press the SETUP button (the LCD displays SET-
UP). Press the UP/DOWN cursor buttons un-
til EDIT appears in the display. Press the ENT
button to confirm.
3. Press the UP/DOWN cursor buttons until CLEAR
ONE KEY appears in the display. Press the
ENT button to confirm.
4. When the SELECT KEY prompt is displayed,
press the command button you wish to
clear.
5. A confirmation message appears in the LCD.
Use the UP/DOWN buttons to select either
YES (to clear the learned command) or NO
(to keep command). Press the ENT button to
confirm.
Clearing All Learned Commands
for a DEVICE/INPUT Button
1. Press the DEVICE/INPUT button where the
learned command is stored.
2. Press the SETUP button (the LCD displays SET-
UP). Press the UP/DOWN cursor buttons un-
til EDIT appears in the display. Press the ENT
button to confirm.