Filter
Top Products
31
Disabling the Beep Tone
As shipped from the factory, the RR-1060 beeps
as confirmation whenever a button is pressed. This
feature can be disabled or enabled as follows:
1. Press the SETUP button (the LCD displays SET-
UP).
2. Press the UP/DOWN cursor buttons until BEEP
SOUND appears in the display. Press the ENT
button to confirm.
3. Press the UP/DOWN cursor buttons until BEEP
ON or BEEP OFF appears in the display. Press
the ENT button to select the desired option.
Clone Function
The CLONE function transfers all programming,
learned commands, labels, and settings from one
RR-1060 to a second RR-1060. To transfer the
programming, place two RR-1060 remotes with
their IR windows facing each other about 2 to 3
inches apart, then proceed as follows.
On the remote that will be receiving
the data:
1. Press the SETUP button.
2. Press the UP/DOWN cursor buttons until
CLONE appears in the display. Press the ENT
button to confirm.
3. Press the UP/DOWN cursor buttons until RE-
CEIVE appears in the display. Press the ENT
button.
On the remote that will be sending the
data:
1. Press the SETUP button (the LCD displays SET-
UP).
2. Press the UP/DOWN cursor buttons until
CLONE appears in the display. Press the ENT
button to confirm.
3. Press the UP/DOWN cursor buttons until
SEND appears in the display. Press the ENT
button.