Filter
Top Products
30 RR-1060
Additional Setup Options
Volume/Mute Punch-Through
In many systems, the volume is adjusted at the TV
set or the A/V processor. For convenience, the
RR-1060 has a Volume Punch-Through feature
that copies the volume and mute commands from
either the TV device or AUD to DEVICE/INPUT
buttons for other components such as CD play-
ers, VCRs, SAT receivers, and DVD players. After
enabling this feature, volume and mute controls
for your choice of the TV or A/V processor are
always available even when one of these other
DEVICE/INPUT command sets is active.
To enable the Volume Punch-through feature:
1. Press the SETUP button.
2. Use the UP/DOWN cursor buttons to select
PUNCH THROUGH on the LCD display. Press
the ENT button to confirm.
3. When the prompt SELECT appears in the
display (after about 2 seconds), use the UP/
DOWN cursor buttons to select either AUD or
TV. This selection is the DEVICE/INPUT whose
volume control you wish to use in other modes.
Press ENT to confirm.
4. When the prompt TARGET appears in the dis-
play, use the UP/DOWN cursor buttons to se-
lect the DEVICE/INPUT where you want the
volume and mute commands to be copied to.
For example, if you want to use AUD volume
even from the CD mode of the remote, select
CD as the target. Press ENT to confirm.
The factory default setting for the Punch-Through
feature is as follows:
AUD: AUD volume
CD: AUD volume
TUN: AUD volume
TAPE: AUD volume
V1: AUD volume
V2: No Punch-Through
V3: No Punch-Through
V4: No Punch-Through
V5: No Punch-Through