Filter
Top Products
19
To program using the brand search:
1. Press the DEVICE/INPUT button where you
wish to program this component’s codes (AUD,
CD, TUN, TAPE and V1–V5).
2. Press the SETUP button (the LCD displays SET
-
UP). Press the ENT button to confirm.
3. Press the UP/DOWN cursor buttons until SET
-
UP BRAND appears in the display. Press the
ENT button to confirm.
4. Press the UP/DOWN cursor buttons until the
type of component you are searching for ap
-
pears in the display (TV, VCR, SAT, CTV, DVD,
CD, etc.) Press the ENT button to confirm. The
first available brand starting with the letter A
appears in the display.
5. Select the first letter of your component’s brand,
using the +/– cursor buttons. Then, use the
UP/DOWN cursor buttons to scroll through
the list until the desired brand appears. Press
ENT to confirm.
6. The brand along with the first available 4-digit
code for that brand appears in the LCD.
7. Press any COMMAND button to test the first
available code for your brand. For example,
if you are testing a code for a TV, you could
press the CH UP button to confirm that the
channel changes on the TV. The 4-digit code
being tested is shown in the display.
If the command button operates the
component, you have found a code that may
work. You can test additional commands by
pressing more COMMAND keys. If success-
ful, press the ENT button to save the code.
If the command button does not work,
press the UP cursor button again to test the
next code for that brand, with the new 4-
digit code being tested shown in the display.
Continue testing codes until you find one that
works, saving it by pressing the ENT button.
8. Press the SETUP button at any time to exit the
programming mode.