Filter
Top Products
22 RR-1060
Learning Commands
From Another Remote
If you are unable to find a command set using
the Programming steps, or if you need addition-
al commands, you can teach the RR-1060 com-
mands directly from your existing remotes. This
procedure is called Learning.
Learning Commands
To teach the RR-1060 the commands from one of
your other remotes, place the two remote controls
end to end as shown in the illustration at the front
of this manual. The IR signals sent by the other
remote must be aimed at the IR emitter/sensor of
the RR-1060.
1. Press the DEVICE/INPUT button where you
wish to learn this component’s codes (AUD,
CD, TUN, TAPE and V1–V5).
2. Press the SETUP button (the LCD displays SET-
UP). Press the ENT button to confirm.
3. Press the UP/DOWN cursor buttons until SET-
UP LEARNING appears in the display. Press
the ENT button to confirm.
4. Press the COMMAND button that you wish to
learn (Power On, CH UP/DOWN, etc.). The
name of that COMMAND button appears in
the display beneath the word LEARNING.
5. Press and hold the corresponding button on
the original remote until the display shows
“OK” indicating that the command has been
learned.
If the LCD shows an ERROR message,
the command was not successfully learned.
Try again.
If the LCD shows a NO DATA message,
no signal was received from the original re-
mote. Adjust the position of the two remotes
and try Step 3 again.
6. To learn additional buttons, repeat steps 4
and 5.
7. Press the SETUP button to exit the learning
mode when you are finished.