Filter
Top Products
Operation
CustomizingYourRemoteControl
After it has been set up properly, your remote control can operate in five different modes: TV, VCR,
Cable, DVD, or Set-TopBox. Pressing the corresponding button on the remote control allows you to
switch between these modes, and control whichever piece of equipment you choose.
NOTE
" The remote control might not be compatible with all DVD Players, VCRs, Cable boxes,
and Set-Top Boxes.
_v_ lava
J<U<=J<aj
V-.\ /_m /Zm
/- hl/- \_
ANT[NNA CHM(,R FAVCH WISELINK
REW SJOP PIAY/PAUS FF
<o_'9T>)
- vo -" CH "
MENU EXIT
CAPTION INFO SLEEP
SINSUNG
\ /
Setting1UptheRemoteto OperateYourVCR
Turnoff your VCR.
iI
i Pressthe VCR button on your TV's remote control.
Pressthe SET button on your TV's remote control.
S_,___
_ii Using the number buttons on your remote control, enter three
/ digits of the VCR code listed on page 40 of this manual for your
brand of VCR. Make sure you enter three digits of the code, even
if the first digit is a "0". (If more than one code is listed, try the
first one.)
' Pressthe POWER button on the remote control. Your VCR should
turn on if your remote is set up correctly.
Ifyour VCR does not turn on after set-up, repeat steps 2, 3 and 4,
but try one of the other codes listed for your brand of VCR.
If no other codes are listed, try each VCR code, 000 through 080.
Note on Using Remote Control Modes: VCR
When your remote control is in "VCR" mode, the volume buttons still
control your TV's volume.
iliii!!iii!iii!iii!iii!iii!iii!iii!iii!iii!ii_English - 36