Filter
Top Products
16
English
Menu Setting Procedures
ALARM RECORDING
This specifies whether alarm recording will be carried
out or not, and sets the recording cycle and recording
conditions when alarm recording is carried out.
1
Select an alarm recording mode from the [ALARM
RECORDING] menu (default setting: OFF).
2
Select the alarm recording method from the
[ALARM INTERLEAVE] menu. (Default setting:
ONLY)
3
Specify the program for recording camera images
from the [PROGRAM GROUP] menu. (See p. 9)
4
Select the recording cycle from the [REC RATE]
menu.
A 60, A 30, A 20, A 15, A 10, 7.5, 6, 5, 4.286, 3.75, 3.333, 3,
2.727, 2.308, 2, 1.667, 1.429, 1.25, 1.111, 1, 0.5, 0.333, 0.25,
0.2, 0.1, 0.05, 0.033 (Units: FPS)
(Default setting: A 30 FPS)
5
Set the duration for alarm recording from the
[DURATION] menu.
5 SEC, 10 SEC, 20 SEC, 40 SEC, 1 MIN, 2 MIN, 3 MIN,
4 MIN, 5 MIN, 10 MIN, 15 MIN, CC, INDIV.
(Default setting: 5 SEC)
The alarm recording duration can be set separately
for each camera. If you select [INDIV.] from the
[DURATION] menu, alarm recording is then carried
out for each camera for the duration of time that has
been set using the [ALARM DURATION SET] menu
that is described later on. (See p. 18)
• OFF: No alarm recording will be carried out.
• ENABLED:
Alarm recording is carried out at any time, without
regard to timer recording (timer settings).
• AL-REC ON TIMER:
Alarm recording is only carried out during timer
recording.
• AL-REC OFF TIMER:
Alarm recording is only carried out at times other
than during timer recording.
• OLY AL-RC ON TMR:
During the time set by the timer, the only recording
carried out is alarm recording, not timer recording.
• ONLY: Only the camera where the alarm was triggered is
recorded.
• SW: The images from the camera where the alarm was
triggered and the images from the cameras
specified by the PROGRAM GROUP setting are
recorded alternately.
OFF: No program group is specified and all camera images
are recorded.
P-1: Specifies program No. 1.
P-2: Specifies program No. 2.
P-3: Specifies program No. 3.
P-4: Specifies program No. 4.
(Default setting: OFF)
L8HBA_US(DSR-3016 NETWORK)(GB only).book 16 ページ ２００３年３月２８日 金曜日 午後６時４４分