Filter
Top Products
English
7
Settings
To use the functions of this unit effectively, the recording conditions and installation environment must
be specified beforehand. These setting items are arranged and displayed in two levels consisting of the
main menu and sub-menus.
Refer to the setting procedures for each menu on the following pages for details on the various setting
methods.
■
■■
■ Menu Selection Method
1
Click the R button on the operating panel to
display the [MAIN MENU] screen.
2
When the specified menu on the [MAIN MENU]
screen is selected and clicked, the sub-menu will
be displayed.
3
Change the required settings from the sub-menu
screen.
4
To clear the menu screen, click the Playback mode
P button on the operating panel to leave the
menu screen and display the live screen.
■
■■
■ Menu Configuration
• Because entry from playback mode is not
possible, click the stop button to return
temporarily to live mode and then click the R
button.
• You must be connected at the ID3 user level in
order to change settings.
• If the main unit is recording, the menu details can
be checked but the settings cannot be changed.
• When moving from one sub-menu to another sub-
menu, first click the R button to return to the
main menu.
Main menu Sub-menu
Reference
page
Recording
conditions
1. CLOCK SET 8
2. DAYLIGHT SAVING/EXT. CLOCK SET • DAYLIGHT SAVING • EXT. CLOCK SET 8
3. PROGRAM REC SET 9
4. RECORDING AREA SET
• TOTAL CAPACITY • RECORDING AREA CAPACITY 10
• AREA FULL RESET (NORMAL, ALARM, ARCHIVE)
5. RECORDING CONDITIONS SET • NORMAL RECORDING AREA OVERWRITE
• ALARM RECORDING AREA OVERWRITE
• REMAINING DISK WARNING
11
6. NORMAL REC MODE SET • PICTURE QUALITY • AUDIO RECORDING
• REC RATE • REC PROGRAM GROUP
12 to 13
7. TIMER SET 14
8. HOLIDAY SET 15
9. ALARM REC MODE SET • PICTURE QUALITY • AUDIO RECORDING
• ALARM RECORDING (ALARM INTERLEAVE, PROGRAM
GROUP, REC RATE, DURATION)
• PRE-ALARM RECORDING (REC RATE, DURATION)
• ALARM TRIGGER
15 to 17
10. ALARM DURATION SET 18
Installation
environment
11. DISPLAY SET • DATE • TIME • QUALITY • AUDIO
• ALARM COUNT • ALARM TYPE
18
12. RS-232C/RS-485 SET
• CONTROL • DATA SPEED • STATUS INFO
• ALARM INFO • ADDRESS
19
13. BUZZER SET • ALARM • DISK FULL • DISK ERROR
• LOCK WARNING • KEY IN • NON REC
19
14. NETWORK SET • IP ADDRESS • SUBNET MASK • GATE WAY • PORT
• PASSWORD SETTING • NETWORK SPEED
20
15. HDD SET
• HARD DISK CAPACITY • MIRRORING
21
• PLAYBACK DRIVE
16. POWER FAILURE/USED TIME
• POWER FAILURE • USED TIME • FIRMWARE 21
*
Shaded items are for information display only.
L8HBA_US(DSR-3016 NETWORK)(GB only).book 7 ページ ２００３年３月２８日 金曜日 午後６時４４分