Filter
Top Products
15
4 ALARM RECORDING
Follow the steps below to have the digital video recorder
record an alarm image only when alarm input is detected
during recording.
z Check that the cable of the device required for alarms is
connected to the ALARM terminal. (JP.8)
1 Set alarm recording.
The default settings are shown below. See P.27 for how to
change these settings.
z ALARM MODE: “ENABLED”
Alarm recording is always performed, whether or not
timer recording is set.
z ALARM DURATION: “20SEC”
Recording is performed for 20 seconds for each alarm
signal received.
2 When alarm input is detected.
z When an alarm is received, “AL” flashes in the
operation display area, the ALARM indicator flashes,
and the alarm image is recorded.
z Each time an alarm is received, the alarm count in the
operation display area is incremented by 1.
3 Ending alarm recording
When the alarm duration time (default setting: 20 seconds)
ends, “AL” disappears from the operating display, the
ALARM indicator stops flashing, and recording ends.
z When the hard disk’s remaining space for recording
reaches zero, the FULL indicator lights and recording
ends. You can start recording from the beginning again
by changing the recording setting. (JP.27)
ALARM
REC/STOP
LOCK/REMOTE
USB
POWER
SEARCH
MENU RESET
MENU
REVIEW
CUE
EXIT/OSD
PLAY/
STOP
STILL
TIMER
FULL
LAN
(LINK/ACT.)
ALARM indicator
Alarm recording
Counts number of
alarms.
e_dsr_m800.book Page 15 Friday, January 31, 2003 5:45 PM